Troubleshooting Submersible Pumps- 4 QUICK FIXES

Basement waterlogging issues is not something new. In fact, those who don’t have a quality submersible pump, they have to face this problem on a repeated basis. Not to forget the hours of removing water and subsequent cleaning which come with it.

It is why investing in a quality submersible pump (be it Grundfos pumps or of any other brand) does seem like a wise investment.

Submersible electric pumps are often considered the true workhorses which operate well for controlling flood and draining away stormwater. They are often quiet in operation, have a low profile and can be installed vertically, horizontal or at any given angle. And if something does go wrong, you can easily fix it.

Just for your knowledge, here are 4 quick fixes which you should keep in mind for these following submersible issues whenever they arise.

If The Motor Doesn’t Start:

Look to check for any blown fuses or existing tripped circuit breaker. Most times, the issue results due to rusted fuse receptacles or dirt accumulation.

All these corrosion and debris leads to irregularity in voltage circulation and so ensure you check for contact points in the pressure switch. Also, examine if anything is bounding the pump. This could be due to sand, and if you find it, dust it off.

If The Overload Protection Constantly Trips:

Constant tripping could result due to excessive heat exposure. So, for starters, check if the overload protectors are not in direct contact with the sun’s rays.

Such trips can also happen if your pump constantly draws incorrect voltage from the site’s temporary power source. If so, then examine the line terminals and resolve the issue.

If The Motor Runs Too Often & Too Continuously:

These two issues are mainly caused due to a leak in the submersible pump system. You can replace these leaks or damages in the pipes and examine the water level to ensure it has not exceeded the pump’s overall capacity.

A malfunctioned pressure switch could cause the pump motor to stay on or run continuously. One way to sort this issue is to inspect the settings and even clean the contracts.

When the motor ceases to shut down, it could also mean that the pump screen is clogged or the check valve has gotten stuck. So make it a point to examine both of them properly.

If It Is Making Excessive Noise:

Noise results due to cavitation, mainly caused by characteristics of water which is often accompanied by a decrease in the pump’s efficiency. Make it a point to inspect the alignment between the pump and the driver.

Also, adjust the pump so that it compensates to the water viscosity.

Try out these quick fixes whenever your submersible pump faces the above-mentioned issues. But if the issue is something more serious, then contact notable Pump Service experts in Wollongong, Sydney to repair/replace it.